Gardsman CTC-1052, Руководство пользователя

Страница: 14 / 46

11
Command 35
Silent Mode

CTC-1052 can be selected to operate in
Silent Mode. This will mute all normal
operation
warning beeps , guard time
tone and key tone .
<NOTE>

Speech Reporting made under Silent
Mode will automatically be switched to
Listen-in, but call recipient can press
DTMF
keys to open two-way
communication or change modes.

If Command #31 is set as Enable ,
CTC-1052 will emit ring tone for
incoming calls even in silent mode.

Silent mode will not mute the long beep
emitted during walk test.
Function
Selection
Result
(0) ON
(Silent)
(1) OFF
(Normal)

Factory Default is set as ( 1 ), OFF .
Command 37
AC Fault Report

The CTC-1052 can be programmed to send
a Fault Report when an AC power failure is
detected.
Function Selection Result
(0)
OFF
(Send No Report)
(1)
ON
(Send Report)

Factory Default is set as ( 1 ), ON .
<NOTE>

Reporting will only be made after
detecting
AC Fault condition
continuously for one hour.
Command 38
Follow-On & Call-Back Function

The Command is available for Digital
Reporting Methods (when Command #20 -
#24 is set as (0), (1) or (2))
Function Selection Result
(0) Follow-On
(1) Call-Back
(2) Follow-On & Call-Back

Factory Default is as (0), Follow-On .

When this function is programmed as ( 0 ),
after a successful reporting to the
Monitoring
Center, CTC-1052 will
automatically enter the Follow-On mode as
specified by Command (
45 ).

When this function is programmed as ( 1 ),
after a successful reporting to the
Monitoring
Center, CTC-1052 will
automatically hang up the line and start a 5-
minute waiting period to auto answer any
incoming phone calls from the Monitoring
Center.

When this function is programmed as ( 2 ),
after a successful reporting to the
Monitoring
Center, CTC-1052 will
automatically enter the Follow-On mode as
specified by Command (
45 ).
Once Follow-On Mode is terminated, CTC-
1052 will automatically start a 5-minute
waiting period to auto answer any incoming
phone calls from the Monitoring Center.

When the Monitoring Center calls back
within the 5-minute period (when call back
function is enabled), CTC-1052 will auto-
answer the call after the 1st-2nd ring and
waits for Access Code (default is 1111) and
the (#) key entry within 15 seconds.
When the correct Access Code is received,
CTC-1052 will then open a Full-Duplex
Communication to allow the Call Recipient
to speak to CTC-1052 directly.
You can use DTMF command to switch the
communicating method. Please refer to
section
4.2. Alarm Activation
.
<NOTE>

The Access Code must be entered