Gardner Denver RBS 15, Руководство по обслуживанию и список запасных частей

Страница: 6 / 62

DRIVE INSTALLATION
When selecting a V-belt drive, check to be sure the
shaft overhung load limitation is not exceeded.
Refer to
FIGURE 2-2
, for overhung load calculations and
limitations.
Belt drives must be carefully aligned. Motor and
blower pulleys must be parallel to each other and
in the same plane within 1/32 inch. Belt tension
should be carefully adjusted to the belt
manufacturer’s recommendation using a belt
tension gauge. Check tension frequently during
the first day of operation.
.
Over tightening belts leads to heavy bearing loads and premature failure.
NOTICE
When changing mounting configuration, it may be necessary to reposition breather/oil fill (B), oil
level gauge (H) and drain plug (A). Refer to Figure 3-1, for correct location.