13-8-639 Page 32
NOTICE
Long condensate removal time at short intervals waste compressed air.
Condensate removal, close time:
Condensate removal close time is in seconds. This is time between condensate removal.
The oil separator light illuminates when this can be programmed.
SERVICE MENU
- To enter the SERVICE MENU from the basic display when the compressor is stopped,
simultaneously push the up arrow and the down arrow keys and hold for 5 seconds, until all the indicator
lights on the display start flashing, then select code 02.
Use the scroll key ( ) to select the desired service option for programming and to reset the service
intervals after the service has been completed. The numerical values can be changed with the up arrow
or the down arrow keys. The value flashes on the display to indicate change. When the flashing stops,
the value becomes the new setting. The following can be programmed through the SERVICE MENU.
Oil change interval:
The service light illuminates when the new oil interval can be set. The factory recommends using
Figure 5-3, page 47, as a guide.
Air filter interval:
The air filter light illuminates when the new service interval can be set for the air filter. See Section
6, page 57, for change intervals.
Air/oil separator interval:
The air/oil separator light illuminates when the new service interval can be set for the air/oil
separator. The factory recommends this be set at 4000 hours.
Oil filter interval:
The oil filter light illuminates when the new service interval can be set for the oil filter. The factory
recommends this be set at 1000 hours.
NOTICE
After replacing the oil, filters or separators, the service interval must be reset in
the controller.
MULTIPILOT MENU
- Contact Gardner Denver Customer Service. To enter the MultiPilot Menu from the
basic display when the compressor is stopped, simultaneously push the up arrow and the down arrow
keys and hold for 5 seconds, until all the indicator lights on the display start flashing, then select code 03.
The settings in this menu are used when the compressor is connected to the optional MultiPilot control
through an RS 485 communication line. An additional printed circuit board is needed. Contact Gardner
Denver Customer Service.
Содержание INTEGRA EFA99F
