Gamry Instruments EIS Box, Руководство оператора, Страница: 23 / 52

Installation
23
If you do not know how to navigate to the Gamry Installation device, consult your local computer expert or
network administrator, or email
techsupport@gamry.com .
AUTORUN.EXE
runs a set-up program. In most cases, you can choose the default choices or the most obvious
choices on all screens shown during the set-up process.
Reboot Your Computer after Software Installation
Reboot your computer when the Gamry Setup program is done. The Setup program normally offers you the
opportunity to do so. Following Setup, you may not be able to use your EIS Box until the drivers are loaded.
Power Cord and Power Connection
The mains are connected to the AC Input jack on the rear of the EIS Box (Fig. 4-2).
The power supply provided inside the EIS Box is rated for operation from 100 to 240 V AC, at frequencies from
47 to 63 Hz. It should therefore be useable worldwide.
The EIS Box is normally supplied with a line cord suitable for use in the United States. In other countries, you
may have to replace the line cord with one suitable for your type of mains (electrical outlet). You must always
use a line cord with a CEE 22 Standard V (IEC 320 C13) female connector on the end of the cable leading to
the unit. This is the same connector used on the US standard line cord supplied with your EIS Box.
Figure 4-2
Rear Panel of the EIS Box
Device driver installation may not occur until a while after the Windows Desktop appears. On
a slow computer, or a busy computer with lots of active applications, the delay before driver installation can
be a minute or more.
AC Input