Gamewell Smart Start IDENTIFLEX 630, Руководство по установке и эксплуатации

Страница: 61 / 226

IF630 Programming 5/26/01
___________________________________________________________________________________________
Rev 3.0 51
PROGRAMMING MODE
Main Display
The main programming display shows the user an overview of the programming modes. The
user is allowed to select from from three categories. (Figure 6)
Programming Mode
1=Ckt. Prog. 2=CBE
3=Function 4=System 0=Exit
>
Figure 6
1= Circuit Prog Circuit Programming
2 = CBE Control-By-Event
3= Function System Test/Bypass
4 = System System Wide Programming
0= Exit Exit
PROGRAMMING MODES
TABLE P1
CIRCUIT PROGRAMMING
Select "Circuit Prog" from the main "Programming Mode" menu to modify input/output
device characteristics (e.g. zone type, group assignment, signal code and device specification
text). (Figure 7)
Circuit Programming
1=Inputs 2=Outputs 3=Init. 0= Exit
Figure 7
____________________________________________________________________________________________
"Inputs" Circuit Selection
1. From the Circuit Programming menu, Press [1] on keypad.
2. Press " Enter ".
Input Circuit Programming
Press an Input Circuit to Program
Press Enter Key to Exit
Figure 7A
3. Select the circuit to be modified. Use circuit select switches located on the front panel display.
(see Figure 1, Common Control Display, Section 2). The LED of the selected circuit illuminates.