Gamewell Smart Start IDENTIFLEX 630, Руководство по установке и эксплуатации

Страница: 100 / 226

IdentiFlex 630 Installation and Operation Manual
S
mart
S
tart Capable
9-25-96
90
COMPUTER/LAPTOP PROGRAMMING OVERWIEW
Overview of
Computer
Programming This section describes the system communications via a computer. System monitoring,
general control functions and system programming can be achieved from a computer
terminal. All figures shown are displayed on the computer screen.
Interconnect
The 14 pin ribbon cable P/N 71332, is used to connect the computer to the CPU Module
port P2. If the SIM-232 card is installed use cable P/N 70704 to connect to the Com2 port
of SIM-232 module. Refer to (drawing # D-W1142).
Communication
Protocol The system communicates with a computer at baud rates of 1200,2400,4800 and 9600 BPS
(see baud rate settings in CPU installation section). The standard protocol is Xon/Xoff,
No Parity, 8 Data Bits and 1 Stop Bit.
Û NOTE: Most standard communication packages for computers
will allow you to set the proper protocol for the
communications port of your computer.
PROCOMM SOFTWARE
Configuration
When using PROCOMM to communicate with your FLEX 600 system the following
configuration should be used. Several areas of the Procomm setup menu and the line
settings menu must be accessed to configure the protocol required.
Line Settings The Line Settings option can be selected by pressing the ALT and P keys simultaneously.
From this menu select the option that your RS-232 port is set for (e.g., 2400,N,8,1 would
be selected if your port speed is set to 2400 baud). The protocol is Baud Rate (port speed
setting), No Parity (N), 8 Data bits (8) and 1 Stop Bit (1).
Setup Menu The Procomm SETUP MENU is accessed by pressing the ALT and S keys simultaneously.
The following screen should appear:
1) MODEM SETUP
2) TERMINAL SETUP
3) KERMIT SETUP
4) GENERAL SETUP
5) HOST MODE SETUP
6) ASCII TRANSFER SETUP
S) SAVE TO DISK