Gamewell FLEXALARM 620, Руководство по установке и эксплуатации

Страница: 25 / 108

Flex 620 System Operation - Revision 5, 11/22/01
_______________________________________________________________________________________________
13
Module Displays
Alarm Display
(Standard)
The alarm display is a multi-purpose display module. The display module provides
LED annunciation of alarm conditions for input circuits, signal circuits, and the city tie.
The display layout is as follows; circuits 1 through 4 are fixed on the left side of the
display (top to bottom). Circuits 5 through 8 are fixed on the right side of the display
(top to bottom). The display is complete with eight tactile switches, eight red LED's
and eight yellow LED's. The eight "point" tactile switches, governing individual
circuits, are used for programming, bypassing, and WalkTest (only zone and signal
circuits can utilize the WalkTest function).
The red LED indicates the circuit is;
!
alarm/alarmed,
!
activate/enabled.
The yellow LED (on steady) indicates;
!
trouble/fault,
!
off normal indication
!
or service is required
!
problem exists
!
check for open
!
short or ground
Relay Module
Display The relay module display is used as a display module. The display is configured with
relays 1 through 4 are fixed on the left side of the display (top to bottom). Relays 5
through 8 are fixed on the right side of the display (top to bottom). The display is
complete with eight tactile switches, eight red LED's and eight green LED's. The eight
"point" tactile switches, governing individual circuits, are used for programming and
bypassing the selected circuit.
The red LED (on steady) indicates;
!
alarm/alarmed,
!
activate/enabled
The green LED indicates;
!
normal
!
not energized
!
feedback point normal
In the programming mode, the green LED (on steady) indicates the relay is selected. If
the green LED is flashing indicates the relay is bypassed.
Building
Control
Display The building control display is used as a control display module. Rotary switches
provide for manual control of the relays. The switch is a three position
ON/OFF/AUTO. The normal position is (AUTO) and the system controls the
operation of building control circuits. The other two positions are for manual
control. The (ON) position activates the ON relay and (OFF) position activates the
OFF relay. The ON relays and/or OFF relays are unable to be active simultaneously
on the same circuit.
The red LED (on steady) indicates;
!
alarm/alarmed,
!
activate/enabled.
The green LED indicates;
!
normal
!
not energized
!
feedback point normal
In the programming mode, the green LED (on steady) indicates the relay is selected.
If the green LED is flashing indicates the relay is bypassed.
Technical Manuals Online! - http://www.tech-man.com