Gamewell FLEXALARM 620, Руководство по установке и эксплуатации

Страница: 76 / 108

Output Circuit - Programming
Signal Circuit
Type
1. Enter the programming mode password. See Password Entry section. Each of
the 'Output Signal Circuit Types' are defined in the "Programming Options"
section.
2. Verify the legend strips are positioned to the Programming Mode.
A. Select the desired output circuit type by depressing the key associated
with the circuit type legend strip until its LED is lit. The following
choices are available for output circuit types:
A. Steady DC (** System Default **)
B. Slow Marchtime (60 ppm)
C. Fast Marchtime (120 ppm)
D. Temporal Code
E. California Uniform Fire Code
B. Once the desired circuit type LED is illuminated, press the "
ENTER
"
key to select the indicated choice.
C. Select all of the output circuits that are to operate as the selected circuit
type by depressing their associated circuit switch. When all of the circuits
are selected (indicated by the circuit LED on) press the
ENTER switch.
Note: To deselect a circuit, press the associated circuit switch until the LED is
extinguished. Any circuit deselected will default to a steady signal and all control by
event information will be removed.
3. If additional Output Circuit Types are required, repeat the procedure from step 2.
____________________________________________________________________________________________
BC Relay
Selection
The BC Relay option selects the appropriate relay (“ON” or “OFF”) of each Building
Control Module circuit to activate when an alarm condition is detected (provided the
circuits are selected in Control By Event).
1. From the programming mode select the BC relay option and press the “ENTER”
key.
2. Select all of the Relays to be activated on each Building Control Circuit by
pressing the circuit key until the appropriate LED is illuminated. The GREEN
LED indicates the “ON” relay will energize and the RED led indicates the “OFF”
relay will energize.
3. After all of the circuits are selected press the “ENTER” key.
4. If additional changes are required, repeat this procedure.
Technical Manuals Online! - http://www.tech-man.com