Game ready Equine 550250, Руководство пользователя

Страница: 17 / 24

15
C A r E A N d S t o r A G E
Cleaning
the Game ready Equine System is a valuable part of your equipment. Please handle the Control Unit as
you would a laptop computer. When you are finished using the system for the day, unplug the Control Unit
from the electrical outlet. disconnect both the Wrap and AC adapter from the Control Unit. Empty the
water and ice from the ice box. the interior of the ice box should be cleaned once every three months.
(See Page 16) to clean the exterior of the Control Unit, simply wipe with a soft cloth rinsed in warm water
and a mild disinfectant
containing any of the following agents:
A. Mild detergent
B. rubbing alcohol
to clean the internal fluid circuit of the Control Unit fill the ice box 3-4 inches deep with hydrogen
peroxide, attach any Wrap and run the unit for 2 minutes with no pressure.
Caution: leave lid open when using hydrogen peroxide.
Storage and transportation Environmental Conditions:
temperature: 1° - 50° C (33° - 122° F)
relative Humidity: 10% - 95% non-condensing
Store the Game ready Equine System in the carrying bag or on a shelf, preferably with the lid open
to allow the interior to dry.
Caution: do not keep in extreme hot or cold temperatures (above 120°F or below 33°F).
Avoid leaving in the trunk of a hot or freezing car.
Cleaning and replacing the Filter
Your Game ready Equine Control Unit is equipped with a special filter designed to keep dirt and debris out
of the fluid system. to assure consistent flow of water through the system, the filter should be checked and
cleaned every three months of regular use. If the filter becomes clogged, the Control Unit alarm will beep,
the
”low flow“ icon will flash, and the unit will go into pause mode.
Caution: do not run the Control Unit without the filter. doing so may cause damage to the unit
and will void your warranty.
In addition to cleaning the filter every three months, it should be replaced after one year of regular usage.
Call us toll-free at 888-GAMErEAdY for a free replacement filter.
to clean or replace the filter, follow these steps:
1. turn off power and unplug the system from its electrical outlet.
2. With the Control Unit in the upright position, open the ice box lid.
3. Empty any water and ice in the ice box.
4. locate the filter inside the ice box with your hand,
as shown in Fig. A.
5. Press the silver metal button on top of the filter, as shown
in Fig. B. You should hear a click as the filter is released.
6. Pull the filter straight out from its housing
(Note: the release button is part of the housing and
therefore remains attached to the inside of the unit).
7. Clean the filter by rinsing it thoroughly under
warm running water. Shake it a few times to clear
out any remaining debris.
8. re-insert the filter in the unit by reaching in and snapping
it back into the housing. You should hear it click into place.
Figure A
Figure B