Revision 1
65
6/27/2017
5.4 Factory Section
The
Factory Parameters
page (Figure 5-13) presents a number of factory set parameters.
Figure 5-13: Factory Parameters Page
When the page is opened, the
Read Only
mode is active.
To change a parameter:
a) Click on the Change to Update Mode field. A prompt for the password entry will appear.
The default password is 9713.
b) Click on the parameter that requires editing. The field for that parameter will change to a
white background.
c) Edit the parameter by typing in a new value. Some parameters such as Fixed
Temperature Enable can be edited by using the pull down selection menu.
d) Press Enter on the keyboard.
e) Press the Save to Unit button. This will cause the changed parameters to be
implemented in the analyzer.
Pressing the
Revert
button before pressing the
Save to Unit
button will undo the edit.
Содержание 943-TGS
