53
Trouble shooting
en
Demo mode
If the
°
symbol appears at the top of the display, this
means that demo mode is activated. The appliance will
not heat up. Disconnect the appliance from the power
supply and then wait for a few seconds before
reconnecting it. Then deactivate demo mode in the
basic settings menu within the next 3 minutes. See the
section entitled
The cooking sensor has overheated and the cooking
zone has been switched off.
“‰ƒ‹ƒ
Wait until the cooking sensor has cooled down sufficiently before acti-
vating the function again.
The cooking sensor has overheated and the adjacent
cooking zones have been switched off.
“‰ƒ‹„
If you are not using the cooking sensor, remove it from the cookware and
keep it away from the other cooking zones and sources of heat. Switch
the cooking zones back on.
The battery in the cooking sensor is almost flat.
“‰ƒ‹…
Replace the 3 V CR2032 battery. See section
The connection to the cooking sensor has been bro-
ken.
“‰ƒ‹†
Switch the function off and then on again.
The cooking sensor is faulty.
“‰ƒ‹‡
Inform the technical after-sales service.
The cooking sensor indicator does not light up and the
cooking sensor is not responding.
Replace the 3 V CR2032 battery. See section
If this does not solve the problem, press and hold the symbol on the
cooking sensor for 8-10 seconds and then reconnect the cooking sen-
sor to the hob. See section
temperature sensor to the control panel"
If the problem still persists, contact the technical after-sales service.
The sensor indicator flashes twice. The battery in the
cooking sensor is almost flat. You may be interrupted
the next time you cook by the battery running out.
Replace the 3 V CR2032 battery. See section
The sensor indicator flashes three times. The connec-
tion to the cooking sensor has been broken.
Press and hold the symbol on the cooking sensor for 8-10 seconds and
then reconnect the cooking sensor to the hob. See section
"Connecting the wireless temperature sensor to the control
The hob is unable to connect to your home network or
the extractor hood.
“ˆ‹‚‹
Switch the hob off and then on again.
If the message appears again, contact our technical after-sales service.
The operating voltage is incorrect/outside of the nor-
mal operating range.
“Š‹‹‹
/
“Š‹‚‹
Contact your electricity supplier.
The hob is not connected correctly
—…‹‹
Disconnect the hob from the mains. Make sure that it has been con-
nected as shown in the circuit diagram.
Problem
Solution
