26
en
Wireless temperature sensor
Replacing the battery
If the temperature sensor does not light up when the
symbol is pressed, the battery is flat.
Changing the battery:
1
Remove the silicone cover from the lower section of
the temperature sensor housing and remove both
screws using a screwdriver.
2
Open the closure of the temperature sensor.
Remove the battery from the lower section of the
housing and insert a new battery (pay attention to
the correct orientation of the battery poles).
Caution!
Do not use any metal objects to remove the battery.
Do not touch the battery connection points.
3
Close the closure of the temperature sensor (the
notches for the screws on the closure must align
with the notches on the lower section of the
housing). Tighten the screws with a screwdriver.
4
Reattach the silicone cover to the lower section of
the temperature sensor housing.
Note:
Use only high-quality batteries of the type
CR2032 in order to guarantee a long service life.
Declaration of Conformity
Gaggenau Hausgeräte GmbH hereby declares that the
appliance with wireless temperature sensor function
meets the basic requirements and other relevant
provisions of the Directive 2014/53/EU.
A detailed RED Declaration of Conformity can be found
online at www.gaggenau.com on the product page for
appliance in the additional documents.
The logos and the Bluetooth® brand are registered
trademarks and property of Bluetooth SIG, Inc. These
trademarks are used by Gaggenau Hausgeräte GmbH
under licence. All other trademarks and brand names
are owned by the respective companies.
