Flex Zone
en
15
10 Flex Zone
You can use the Flex cooking zone as a single cooking
zone or as two independent cooking zones. The Flex
cooking zone consists of four inductors. The inductors
work independently of each other and only activate
area of the hob that is covered by the cookware.
10.1 Cookware positions for a single
cooking zone
This is where you can find an overview of the position-
ing of the cookware.
In order to guarantee good pot detection and heat dis-
tribution, position the cookware in the centre.
For a diameter of up to
13 cm, position the cook-
ware on one of the four
positions as shown in the
illustration.
For a diameter over
13 cm, position the cook-
ware on one of the three
positions as shown in the
illustration.
If the cookware covers
more than one cooking
zone, position the cook-
ware starting on the up-
per or lower edge of the
flexible cooking zone.
10.2 Cookware positions for two
independent cooking zones
This is where you can find an overview of the position-
ing of the cookware.
You can use the front and rear cooking zones with two
inductors each independently of each other. Set the re-
quired power level for each individual cooking zone.
Use just one item of cook-
ware on each cooking
zone.
10.3 Using the Flex cooking zone as a
single cooking zone
Requirement:
The cooking zones are connected.
"Connecting the two cooking zones", Page 15
▶
Use the entire cooking zone.
Connecting the two cooking zones
1.
Set down the cookware.
2.
Turn one of the control knobs to .
3.
Use the other control knob to select the power level.
a
lights up.
a
The power level lights up in the displays for both
cooking zones.
a
The Flex cooking zone has been activated.
Changing the power level
▶
Change the power level using the same control
knob that you used to select the power level.
Adding new cookware
1.
Set down the new cookware.
2.
Turn the control knob that you used to select the
Flex cooking zone to and then to .
a
The new cookware is detected and the heat setting
that was previously selected is retained.
Note:
If you move cookware on the cooking zone that
is being used or lift it, the hob starts an automatic
search and the heat setting that was previously selec-
ted is retained.
Separating the cooking zones
▶
Turn the control knob that you used to select the
Flex cooking zone to .
a
The display lights up.
a
The Flex cooking zone is deactivated.
a
The two cooking zones operate as two independent
cooking zones.
Note:
If you switch off the cooking zone and switch it
back on again, the flexible cooking zone is switched
back to two independent cooking zones.
10.4 Using the Flex cooking zone as two
independent cooking zones
▶
Use the Flex cooking zone as two independent
cooking zones.
→
