Gaggenau CV482105, Инструкция по эксплуатации

Страница: 14 / 36

en
Basic operation
14
9.11 Switching on intermittent ventilation
For intermittent ventilation, the appliance switches on
the ventilation for six minutes per hour each time.
Requirement:
A power level is selected.
▶
Press or repeatedly until lights up.
a The intermittent ventilation is activated.
Note:
If you switch off the appliance, the intermittent
ventilation is switched on.
9.12 Switching off intermittent ventilation
▶
Use to set the required power level ⁠.
a The intermittent ventilation is switched off.
9.13 Deactivating demo mode
The appliance does not heat up in demo mode. If
is lit up, demo mode is activated.
1.
Disconnect the appliance from the mains power
supply.
2.
Wait 30 seconds.
3.
Reconnect the appliance.
‒
Deactivate the demo mode within the next
three minutes.
4.
Turn one of the control knobs anti-clockwise to ⁠.
5.
Turn the same control knob clockwise to ⁠.
6.
Turn the same control knob anti-clockwise to ⁠.
a
The illuminated ring on the control knob lights up
yellow.
7.
Turn the same control knob clockwise to ⁠.
a
lights up.
a
The illuminated ring on the control knob lights up
green.
8.
Wait approx. five seconds.
a
lights up.
a
The illuminated ring on the control knob lights up
yellow.
a
The demo mode is deactivated.
9.14 Changing the colour of the illuminated
ring
Note:
The illuminated ring on the control knob lights up
orange during operation. You can choose between a
lighter and a darker orange.
1.
Carry out the following operating steps without inter-
ruption.
2.
Push in the control knob and turn it anti-clockwise to
the ⁠ position.
Leave the control knob pushed in.
3.
Turn the control knob clockwise to ⁠.
Leave the control knob pushed in.
4.
Turn the control knob anti-clockwise to ⁠.
a
lights up.
a The illuminated ring on the control knob lights up
yellow.
a The menu for changing from orange is open.
5.
Push in the control knob and turn it clockwise to ⁠.
a After approx. 5 seconds, the illuminated ring on the
control knob lights up green.
a The colour has changed.
Changing the colour back
Requirement:
You are in the menu for changing the or-
ange colour.
→
"Changing the colour of the illuminated ring",
Page 14
▶
To change the setting back, push in the control
knob and turn it anti-clockwise to and back to ⁠.
a
The illuminated ring on the control knob lights up
green.
Exiting the menu and saving the settings
1.
Push in the control knob and turn it anti-clockwise to
the ⁠ position.
Leave the control knob pushed in.
2.
Turn the control knob clockwise to ⁠.
Leave the control knob pushed in.
3.
Turn the control knob anti-clockwise to ⁠.
a
The illuminated ring on the control knob goes out.
a
The settings are saved.