en
Familiarising yourself with your appliance
10
Switching on the stopwatch
Setting the kitchen timer
1
The symbol can light up orange or white.
Indicators on the display
The displays show set values and functions.
Operating status
Cooking zone
-
Power levels
-
Fan settings
Frying sensor function
PowerBoost function for cooking zones/in-
tensive mode for ventilation
/
Residual heat
Kitchen timer
.
Stopwatch function
Control panel lock for cleaning
Flex function activated
Flex function deactivated
Ventilation system is switched on
1
Intensive mode for the ventilation system
1
Intermittent function for the ventilation sys-
tem
Ventilation system automatic mode
/ /
Frying sensor temperature indicator
Fan run-on
Odour filter saturation indicator
1
Home network
1
The symbol can light up orange or white.
Touch fields and displays
When the hob is switched on, the symbols for the cur-
rently available touch fields light up. The displays for
the selected cooking zones or functions light up or-
ange.
Touch a symbol to activate the corresponding function.
An audible confirmation signal sounds.
¡
Always keep the control panel clean and dry. Mois-
ture reduces its effectiveness.
¡
Do not place any cookware near the indicators or
touch fields. The electronics may overheat.
Control knobs
You can use the control knobs to set some functions of
your appliance and to obtain information about the op-
erating status.
The markings on the control knob show the assign-
ment to each cooking zone and the setting from power
level 1 to 12 or the PowerBoost function and the flex
function.
0–12
Setting the power level
Activating the PowerBoost
function
Activating the flex function
Setting the front left cook-
ing zone
Setting the rear left cook-
ing zone
Setting the rear right
cooking zone
Setting the front right
cooking zone
Indicators on the illuminated rings
Each control knob is encircled by an illuminated ring
with various display functions.
The illuminated ring on the control knob lights up or-
ange during operation. You can choose between two
colour shades. If you have several appliances installed
next to each other, you can change the shades in the
settings for the appliances so that all of the illuminated
rings light up in the same shade.
→
"Changing the colour of the illuminated ring",
Display
Name
Off
Appliance OFF
Lights up: Orange
Appliance ON
Flashing: Orange
Appliance OFF
Residual heat indicator
Light up: Blue
Home Connect
Flash: Blue
Home Connect, appliance
is connected to the home
network
Flashing alternately: Or-
ange and white
Safety switch-off function,
power failure
Flashing alternately: Yel-
low and magenta
Appliance fault.
Call customer service.
Lights up: Green for a few
seconds, then turns yel-
low
The appliance is initial-
ising during initial connec-
tion or following a power
failure