Gaggenau BOP 251 2 Series, Инструкция по эксплуатации

Страница: 15 / 56

14
en
Operating the appliance
1
Operating the appliance
Operating the appliance
Cooking compartment
m
Warning – Risk of scalding!!
The inside of the appliance door becomes very hot
during operation. Always open the appliance door as far
as it will go. Ensure that the appliance door does not
swing back. Avoid contact with the inside of the
appliance door.
The cooking compartment has four shelf positions. The
shelf positions are counted from the bottom up.
Caution!
–
Do not place anything on the cooking compartment
floor. Do not cover it with aluminium foil. A build-up
of heat could damage the appliance.
– Do not slide any accessories between the shelf
positions, or they may tip.
Inserting accessories
The accessories have a locking function.The locking
function prevents the accessories from tilting when they
are pulled out.The accessories must be inserted into the
cooking compartment correctly for the tilt protection to
work properly.
When inserting the wire rack, make sure that
▯
the lug ¨ is pointing downwards
▯
the safety bar © on the wire rack is at the back and
on top.
Switching on
1 Set the required heating mode using the function
selector. The chosen heating mode and the default
temperature are displayed.
2 If you want to change the default temperature:
set the required temperature with the rotary
selector.
The preheating symbol
’
appears on the display. The
bar continuously shows the preheating status. When the
set temperature is reached, a signal sounds and the
preheating symbol
’
goes off.
Note: The oven interior lighting stays switched off at a
temperature setting below 70°C
Switching off:
Turn the function selector to 0.
Rapid heating
With the "Rapid heating" function, your appliance
reaches the temperature you require particularly quickly
in the "top heat", "bottom heat" and "top+ bottom heat"
types of heating.
To ensure an even cooking result, do not place your
food in the cooking compartment until "Rapid heating"
is complete and the heat-up symbol
’
has gone out.
Note: The "Rapid heating" function is preconfigured in
the factory settings. You can select "Rapid heating"
’
or "Heat-up"
“
in the basic settings. ~
"Basic
settings" on page 29
Safety shut-off
For your protection, the appliance is equipped with an
automatic safety shut-off. Any heating process is
switched off after 12 hours if the oven is not operated in
this time. A message appears in the display.
Exception:
The long-term timer has been programmed.
Set the function selector to 0, then the appliance can be
operated again as usual.
15
Timer functions
en
O
Timer functions
Timer functions
You use the timer menu to make the following settings:
Š Short-term timer
p Stopwatch
6 Cooking time (not in standby mode)
5 Cooking time end (not in standby mode)
Calling up the timer menu
You can call up the timer menu from any mode. Only
from the basic settings, function selector is set to S, the
timer menu is not available.
Touch the M symbol.
The timer menu is displayed.
Timer
The timer runs independently of the other appliance
functions. You can enter a maximum of 90 minutes.
Setting the timer
1 Call up timer menu.
The "Timer"
Š function is displayed.
2 Turn the rotary selector to set the required cooking
time.
3 Start with I .
The timer menu closes and the time begins to count
down. The
Š symbol and the countdown appear in the
display.
A signal sounds once the time has elapsed. Touch the
™ symbol to silence.
You can exit the timer menu at any time by pressing the
' symbol. This erases the settings.
To stop the timer:
Call up timer menu. Touch
C to select the "Timer" Š
function and touch the H symbol. To allow the timer to
continue counting down, touch the symbol I .
Switching off the timer early:
Call up timer menu. Touch
C to select the "Timer" Š
function and touch the Ž symbol.
Stopwatch
The stopwatch runs independently of the other
appliance functions.
The stopwatch counts from 0 seconds up to 90 minutes.
It also has a pause function, which enables you to
temporarily stop the clock.
Starting the stopwatch
1 Call up the timer menu.
2 Touch C to select the p "Stopwatch" function.
3 Touch I to start.
6KRUWWHUPWLPHU
6WRSZDWFK