GAC GS5, Руководство пользователя

Страница: 119 / 285

4. Operating System and Equipment
Mobile Phone Wireless Charging Fault
Abnormal Scenario Content of Prompt
Internal over-
temperature of wireless
charging module
Over-temperature,
please remove your
phone and try again later
Existence of foreign
metal article in the
placement area of
wireless charging
module
Foreign metal article
existing, please remove
it and place your mobile
phone again
Power supply voltage of
wireless charging
module too low or too
high
Abnormal voltage,
please remove your
phone and try again later
Charging power
requested by the
receiving end too high,
or transmitting power of
wireless charging
module too high
Abnormal power, please
remove your phone and
try again later
Abnormal status at the
receiving end
Charging interrupted,
please remove your
phone and try again later
Hint
• Only one mobile phone can be charged at a
time.
• To ensure normal charging of mobile phone,
make sure that the center of the mobile phone
is aligned with the Qi logo in the front storage
box as far as possible.
• For AT models, opening a door will interrupt
the charging function. Make sure that all the
doors are closed during charging.
• While the vehicle is running on a bumpy road,
mobile phone wireless charging could
interrupt intermittently then resume. If the
charging stops due to mobile phone departure
from the charging area, move the mobile
phone back to the charging area.
• Any fault of the system or the mobile phone
may result in a failure to charge.
• The mobile phone charging may stop at too
high temperature, and resume charging after
the temperature drops.
Caution
• Do not place anything between the mobile
phone and the charging panel during
charging. Non-metallic articles may degrade
the charging performance. Articles such as
magnetic cards or chip cards may be
damaged. Foreign metal articles such as keys
and coins may be heated, posing a driving
safety hazard.
• Disable the wireless charging function before
placement of any foreign metal article in the
front storage box. Otherwise, the metal article
may slide into the charging area and be
heated during driving, posing a safety hazard.
• During mobile phone wireless charging, if any
foreign metal article is found between the
mobile phone and the rubber pad, do not
remove it immediately to prevent finger
burning. In this case, immediately disable the
system, and remove the article after cooling.
• Please never sprinkle water in charging area,
lest the water enters wireless charger module
through the clearance of rubber pad to cause
wireless charger module faults.
119
113