G-WEIKE LF1390, Инструкция по использованию

Страница: 68 / 75

G.Weike Laser
Profession Laser Manufacturer more than 15 Years.
61
Caution: Please put the different kinds of lens in the right position as the picture
6-4 .
Protection lens dismantle
Picture 6-5 Picture 6-4
1.Turn left the switches on picture 6-5
Picture 6-6 Picture 6-7
2. Using the wrapping paper to seal the part marked by the green rectangle on the picture
6-6.
Note : before installing optical lens wear clean, with soap or
detergent to clean hands, and wear clean white thin gloves;
It is strictly prohibited to any part of the hand contact
lenses;Take glasses, should be put on the gloves, and from
the side of the lens to take, do not touch the lens coating on
the surface directly.

When assembling the lens, do not use mouth blowing toward the lens;
Smooth lens should be placed in clean the table, the following a few pieces
of lens paper pad. Should try to be careful when you pick up the lens to
prevent collision and fall, and on the surface of the lens coating, not exert
any force; Install the lenses mirror should be clean, with a clean air spray
gun cleaning lens seat in the dust and dirt, and then remove the lens,
gently put her seat.

When install the lens to the lens holder, fixed lens don't use too much
power, in order to avoid the lens distortion, which affect the quality of the
beam.

Replacing the optical lens of note: be very careful when remove the lens
from inside the box, to prevent the lenses that touch an injury; Before
wrapping paper were open, not to put any pressure on the lens; Take out