G-WEIKE LF1390, Инструкция по использованию

Страница: 29 / 75

G.Weike Laser
Profession Laser Manufacturer more than 15 Years.
22
One end of the power cord is a plug; insert it in to the socket 'AC INPUT' on the
rear panel .Notice that the plug is wrong-side preventing. After insert it, lock it
with the lever.
The other end of the power cord is stripped off. There are five wires labeled L1,
L2, L3, N and PE, respectively. You should connect the wires to the AC power
supply according to the labels:
L1~L3-Phase Line
N-Neutral Line
PE-Protective Earth
Modulation Input
Picture 4-10
The 24V modulation signal should be applied to connector as in (Picture 4-8
)“3” We provide a cable for the connector, which shows in (Picture 4-10)
RS-232 Serial Port
Picture 4-10
Please insert the wire on the (Picture 4-10) nto rs-232 serial port.
More details please check the attached Fiber Laser User Guide Manual.Please
kindly read every details of the manual before operate the machine
The machine for fiber laser light path no need to debug, but it must be
strictly to put optical fiber placement within the axis drag chain operation,
and must ensure that bending radius is larger than 200 mm. Ban
movement radius is less than 200 mm, fixed radius is less than 100 mm.
Take fiber from pan fiber spin out slowly, drag along the fiber imported
machine tool and the shaft. Ensure the water pipe and air pipe is normal no
leakage!
Before QBH inserted must ensure QBH head clean, clean according to the
following method: using a special microscope observation components QBH
head, using a dedicated compressed air or professional cleaner
(ethylene propylene glycol) as well as cleaning tools fiber cotton swabs, lens