G-WEIKE LF1390, Инструкция по использованию

Страница: 34 / 75

G.Weike Laser
Profession Laser Manufacturer more than 15 Years.
27
Please be sure that all the laser head connectors are locked and tightened by
screw-plug before using, or the laser head will not work if there are gas or liquid
entering into it.
Picture 4-18
Cutting gas G1/8 connector(depth 8mm)
Caution: cutting gas
Only pure and dry cutting gas are useful.
Cutting gas meet the standard of ISO 8573-1:2010, Class 2.4.3 (particle, water,
oil)
Maximum pressure on laser head is2.5MPa.
3.
Optical fiber introduction
This series of cutting head is suitable for most industrial fiber, and the fiberis
imported by the optical fiber connecting block.
Sequence of operation:
1. The connection block at the top of the plastic protective cover is takenoff.
2. The QBH hole alignment connecting the hole in the block, insert the QBH
line in the end.
3. Clockwise to tighten connection fixing nuts block, as shown in Picture 4-18.
4. On fixed nuts again along clockwise to tighten.
Laser Optical Access
Caution :Keep clean on the working platform.Do the assemble and change
work in very clean working environment, dust or dirty things are not allowed in
collimator part, it will lead to laser head damage.
Picture 4-19
Fiber Access (QBH Connector)
Picture 4-19: 1. fiber plug 2 .QBH connector
Clean the air :set the air processing component for service mode.