G-WEIKE LF1390, Инструкция по использованию

Страница: 11 / 75

G.Weike Laser
Profession Laser Manufacturer more than 15 Years.
4
Notice: Comprehensive careful reading machine manual
and electric schematic diagram, in order to be familiar with
the various functions and the corresponding key operation
method.
a). The operator can
’
t repair the electrical parts and laser parts by
himself .This machine must be repaired by professional engineers .
b). Don't open the electrical cabinet, prohibit to change the machine
parameters has been set. If you need to change, must be approved by
equipment manufacturing factory training and obtain the professional operation,
and record the changes before the values of the parameters, so that when
necessary, can restore the original state.
c). With the laser processing, general power supply voltage for the a few kv to
tens of thousands of volts, should prevent laser tube under high voltage and high
voltage generated X-ray damage danger.
1.9 Machine protective measures
1) Specified security administrator, determine the scope of their duties, and do
safety operation and safety education to the laser processing operator.
2) Specify laser safety management area, set up the warning card in the
management area entrances to , content including: the power of laser machine,
laser type, not allowed to enter, protect eyes and security manager's name, etc.
3)When not use laser processing machine, should break total power, avoiding
cause harm due to wrong operation.
4) Put smoke and dust produced in the process of machining and laser gas
emissions through the exhaust pipe to air filter, all gas cylinders should be neat
and firm.
Note : Please wear the gas mask when operating then machine
or near the processing area or operation area.
1.10 Common sense of operator
a).Operator must receive special training by our company engineer or other
professional engineers, to reach a certain level, under the premise of the
agreement of security administrator, then can operate.
b).Machine operator or person who close to the laser during use laser, should
be put on the appropriate laser protective goggles, and wearing protective
clothing, in the area of the wear protective goggles must have good indoor
illumination, in order to make sure operator operating smoothly.
c).In order to protect the operator, there must have a processing chamber or
protective screen around the set. In the processing room should have
protective laser diffusion device to protect operator; When open door of