G-WEIKE LF1390, Инструкция по использованию

Страница: 42 / 75

G.Weike Laser
Profession Laser Manufacturer more than 15 Years.
35
5.3 Adjusting laser head height and turn on the software
5.3.1 Standardization
Plates will be put to the cutting table, through the operation handle above the
laser head to move to a board, [NC] button at the top of the click software, the
pop-up dialog box, use the mouse to click on [F1] calibration - Calibration [2]
floating, mouse the left key long press down arrow of the laser head moves to
the plate 1 cm above the place, click OK, until after the calibration is complete
(the degree of stability, smoothness in benign and above), click save, calibration
is completed. As shown in Figure 4-19,,4-20
Picture 5-7 Calibration initial interface
Picture 5-8 Calibration interface
Note :the height adjusting system may be modified, with its own independent
specification shall prevail; this manual is only for reference.(More details please
refer the height controller use manual).
5.3.2 Control software operation process
Making graphic data---data check---Making process parameters---Simulation
processing---Processing output (More details please refer the attached use
manual of the control software)
Turn on the software---leading-in---Find the corresponding format has been
painted graphics. As shown in picture 5-9.
Set graph size, as shown in picture 5-10.
Set the lead outlet and lead inlet, as shown in Picture 5-11.
Sort; choose Small graphics priority as show in Picture 5-12.
Simulation, as shown in Picture 5-13.