FUTABA FDL01TU, Инструкция по эксплуатации

Страница: 68 / 83

54
To use it more securely, it is recommended to readout the
local serial ID code
with
TID command and pad it (either all or a part of it) in the transmitting packet.
When no packet is received, “All Zero” is displayed as the result of this command
execution.
The
serial ID code
is no relation with
ID code
setting of REG04 and 05.
Example
>
@
RID
CR/LF
: requests the received remote station’s
serial ID code
< XXXXXXXXXXXX
CR/LF
:outputs the received remote station’s
serial ID code
RNO Reference and Set Retransmission Count
Syntax
RNO (:Retransmission count) {; Local Station Address}
Retransmission count : maximum number of retransmissions (000 to 255)
Local Station Address :
local station address
for
485 mode
(000 to A22).
Response
xxx : current set value
P0 : command accepted
N0 : command error (Except 485 mode )
Function
This command references or sets the
number of retransmissions (retransmission
count) to attempt before making decision as transmission failure.
The current value can be referenced by issuing the command with no parameter.
RNO command is used to temporarily change the retransmission count . To
change the default value, change the setting of
REG11
.
Example
>
@
RNO
CR/LF
: reference the
retransmission count
<050
CR/LF
: output the current set value (50 times)
>
@
RNO010
CR/LF
: set the
retransmission count
to 10 times
<P0
CR/LF
: command accepted
ROF RF Circuit Block Power Down
Syntax
ROF{Local Station Address}
Local Station Address :
local station address
for
485 mode
(000 to A22).
Response
P0 : command accepted
N0 :
command error
(Except
485 mode
)
Function
Turn off the power of RF circuit block and stops RF operation.