FUTABA FDL01TU, Инструкция по эксплуатации

Страница: 67 / 83

53
While rewriting the
memory register
, do not turn off the power until
response
is
output. Otherwise, the memory registers content may be collapsed.
When the response of the memory register write error is output, set the values
after initializing the
memory register
.
REN Reception Enable
Syntax
REN{Local Station Address}
Local Station Address :
local station address
for
485 mode
(000 to A22).
Response
P0 : command accepted
N0 :
command error
(Except
485 mode
)
Function
Enables wireless reception in the packet transmission mode .
The status when the modem is powered ON or reset follows bit 7 of REG22 .
Use this command to enable wireless reception after reception is disabled with
the
RDA command
.
Example
>
@
RDA
CR/LF
:
disable wireless reception
<P0
CR/LF
: command accepted
>
@
REN
CR/LF
: enable wireless reception .
<P0
CR/LF
: command accepted
RID Display Received Serial ID
Syntax
RID{Local Station Address}
Local Station Address : local station address for 485 mode (000 to 999).
Response
XXXXXXXXXXXX : displays the received serial ID code
（
12 digits
）
N0 :
command error
(Except
485 mode
)
Function
Outputs the serial ID code in the received packet and displays it.
The serial ID code consists of 12 digits; upper three digits are 0 and the lower 9
digits are the
product serial number
of the transmitted-end modem.
Be noted that the
serial ID code
of the packet received last is displayed. When
packets are received from multiple stations and their data are stored in the receiving
buffer, those data may not be correspond to the
serial ID code
readout with
RID
command .