Furuno TZTL12F, Руководство по установке

Страница: 26 / 67

2. WIRING
2-4
2.3.3 How to connect the external buzzer
Note: The external buzzer does not require menu settings.
1. Cut the XH connector at the end of the external buzzer cable to an appropriate
length for your installation.
2. Referring to the figure below, place heat shrink tubes on the wires, then solder the
connection point.
3. Move the heat shrink tubes to the soldered connection, then apply heat to the
tubes.
4. Secure the buzzer with double-sided tape (local supply) or two self-tapping
screws (3

15 or 3

20, local supply).
5. Secure any unused wires, referring to "How to isolate and secure unused
wires" on page 2-3.
2.3.4 How to connect and set up the event switch
1. Referring to the figure below, connect, then solder, the orange wire and black wire
from the MULTI cable to the event switch.
2. Secure any unused wires, referring to "How to isolate and secure unused
wires" on page 2-3.
3. Tap the [Home] icon to show the home screen and display mode settings.
4. Tap [Settings], then drag the menu to show [Initial Setup]. Tap [Initial Setup].
5. Drag the menu to show [Event/Buzzer Port Configuration], then tap [Event/Buzzer
Port Configuration].
Red wire
Gray wire Black wire
Solder the connection point, then set
the heat shrink tube to the cores.
Secure unused
wires with tape here
External
buzzer External
buzzer
External buzzer connection example
Multi cable
Black wire
Solder connection point
Solder connection point
Event
switch Event
switch
Secure unused
wires with tape here
Orange wire
Multi cable
Event switch connection example