Furuno TZTL12F, Руководство по установке

Страница: 39 / 67

3. HOW TO SET UP THE EQUIPMENT
3-5
3.3 Initial Setup
This section shows you how to set your system according to the sensors you have
connected.
Note: Some units are set to metric in this section, actual setting ranges vary
depending on the unit of measurement set in the [Units] menu.
1. Tap the [Home] icon to show the home screen and display mode settings.
2. Tap [Settings] to show the [Settings] menu.
3. Drag the main menu, then tap [Initial Setup] to show the [Initial Setup] menu.
4. Referring to the tables on the following pages, set your equipment.
[Initial Setup] menu - [GPS POSITION]
[Initial Setup] menu - [DATA ACQUISITION]
Menu item Description Options (setting range)
[Longitudinal (from
bow]
Referring to the figure on the
right, enter the GPS antenna
positioning bow-stern
(Longitudinal) and
port-starboard (Lateral)
position from the origin.
0 (m) to 999 (m)
[Lateral (-Port)] -99 (m) to +99 (m)
Menu item Description Options (setting range)
[Boat Length] Set the length of your boat. 0 (m) to 999 (m)
[Size of Static Icon] Set the size of static (such as own ship)
icons. 50 to 150
[Depth Display] Select the start point for depth measure-
ment. [Under Keel],
[Under Sea Level]
[Transducer Draft] Set the transducer draft. 0.0 (m) to 99.9 (m)
[Keel Draft] Set the keel draft. 0.0 (m) to 99.9 (m
[Graphic Instruments
Setup] See "[Initial Setup] menu - [GRAPHIC INSTRUMENTS
SETUP]" on page 3-7.
[Engine & Tank Setup] See "[Initial Setup] menu - [ENGINE & TANK SETUP]" on page 3-8.
Menu Item Description Options (setting range)
[GP330B WAAS Mode] Select [ON] to use the WAAS mode for the
corresponding GPS antenna. [ON], [OFF]
[WS200 WAAS Mode]
[Data Source]
Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. The FURUNO products are shown at the upper part of the list.
[Sensor List] Show the information for sensors connected to your equipment. Also,
you can set “Nickname” for them here.
[NMEA0183 Output] [Port Configuration] - [Baud Rate]: Select
the output baud rate. [4,800], [9,600], [38,400]
[Port Configuration] - [NMEA-0183 Ver-
sion]: Select the NMEA0183 version for
output. [1.5], [2.0], [3.0]
[Sentences]: Select the sentences to out-
put. [ON], [OFF]
[NMEA2000 PGN Output] Select [ON] for the PGN's (Parameter Group Number, CAN bus
(NMEA2000) message) to output from the CAN bus port.
Origin Origin