Furuno TZTL12F, Руководство по установке

Страница: 44 / 67

3. HOW TO SET UP THE EQUIPMENT
3-10
How to align the antenna heading
You have mounted the antenna unit facing straight ahead in the direction of the bow.
Therefore, a small but conspicuous target dead ahead visually should appear on the
heading line (zero degrees).
In practice, you will probably observe some small bearing error on the display because
of the difficulty in achieving accurate initial positioning of the antenna unit. The follow-
ing adjustment will compensate for the error.
1. Set your radar with 0.125 and 0.25 nm range and the head up mode.
You can select a range by using the pinch action. The range appears at the bottom
right of the screen. Range may also be selected using the slide bar displayed on
the right-hand side of the radar display area. Drag the bar up to zoom in, or down
to zoom out.
2. Turn the vessel’s bow toward a target.
3. Tap the [Home] icon to show the home screen and display mode settings.
4. Tap [Radar] to show the [Radar] menu.
5. Drag the [Radar] menu to show the [RADAR INITAL SETUP] menu.
6. Tap [Antenna Heading Align].
7. Key in the offset value so that the target is displayed at the very top of the screen
(setting range: +179.9° to -180°, +: clockwise direction, -: counterclockwise direc-
tion), then tap the
icon.
8. Confirm that the target echo is displayed at correct bearing on the screen.
[Radar Optimization] Automatically adjust magnetron output and tuning for the
connected radar.
For service personnel only. Do not change these settings.
[ARPA Advanced Settings] For service personnel only. Do not change these settings.
[Set Hardware To Factory De-
fault] Resets the radar selected at
[Radar Source] to factory default. [OK], [Cancel]
[Reset Default Settings] Resets [Radar] menu settings to
default. [OK], [Cancel]
Menu item Description Options (setting range)
Range
Increase range Increase range Reduce range Reduce range
Radar indications
HU
NM
Tx
3.650