Furuno TZTL12F, Руководство по установке

Страница: 25 / 67

2. WIRING
2-3
2.3.1 How to isolate and secure unused wires
1. Cut the outer and inner sheaths lengthwise. Take care not to cut the wires.
2. Fold back the outer sheath, then fold back the inner sheath, covering the outer
sheath.
3. Individually isolate unused wires using vinyl tape, then secure the unused wires
as shown in the figure below.
2.3.2 How to set up NMEA0183 data output
Note: To set up data input from NMEA0183 equipment, see "NMEA0183 equipment
data input" on page 2-7.
1. Cut the XH connector at the end of the external buzzer cable to an appropriate
length for your installation.
2. Referring to the figure below, place heat shrink tubes on the wires, then solder the
connection point.
3. Move the heat shrink tubes to the soldered connection, then apply heat to the
tubes.
4. Isolate and secure unused wires as shown in paragraph 2.3.1.
5. Tap the [Home] icon ( ) to show the home screen and display
mode settings.
6. Tap [Settings], then drag the menu to show [Initial Setup]. Tap [Initial Setup].
7. Drag the menu to show [NMEA0183 Output], then tap [NMEA0183 Output].
8. Tap [Baud Rate] to set the output baud rate. Available options are [4,800], [9,600]
and [38,400]. Tap the appropriate setting then tap the icon.
9. Tap [NMEA-0183 Version] to set the version. Available options are [1.5], [2.0] and
[3.0]. Tap the appropriate setting then tap the icon.
10. Select the appropriate sentences to output, then tap the flipswitch to set the
sentence to [ON].
11. Tap the [Close] icon at the top right of the screen to close the menus.
Isolate unused wires with vinyl tape Secure unused wires to outer sheath with
vinyl tape
Outer sheath Outer sheath Outer sheath Outer sheath
Inner sheath Inner sheath
Solder the connection point, then set
the heat shrink tube to the cores.
Secure unused
wires with tape here
Multi cable
TD-B wire
(blue) RD-B wire
TD-A wire
(white)
RD-A wire
NMEA0183
equipment NMEA0183
equipment