Furuno NAVpilot-300, Руководство оператора, Страница: 11 / 101

1-1
1. INTRODUCTION
The NAVpilot-300 can be controlled either from the Control Unit (FAP-3011) or from
the Gesture Controller (GC-001). For details regarding the GC-001, see chapter 5.
1.1 Controls Overview
The keys beep when operated to inform you if the operation was successful, or if the
operation is not allowed. One beep indicates successful operation, two beeps indi-
cates an operational error.
You can turn the key beeps off or on to suit your needs. See section 4.4 for details.
The figure below shows the FAP-3011 control unit. For GC-001 controls, see
chapter 5.
The table below outlines the basic functions of the items highlighted in the figure
above. Detailed instructions on their use is described chapter 2.
Name Description
PORT 10 key Short press:
• With Auto active: Change course by 10° to port.
• Open the selected setup menu.
Long press:
• With Auto active: Start a 180° (factory default) turn to port.
• With NAV mode active: Switch to Dodge (port turn) mode
PORT 1 key Short press:
• With Auto active: Change course by 1° to port.
• Increase the value for the selected setting.
• Move the selection cursor upwards in the menu.
• With the system in STBY: Switch between digital indications
and dial indications.
Long press:
• With Auto active: Start a 90° (factory default) turn to port.
10
1