Furuno NAVpilot-300, Руководство оператора, Страница: 56 / 101

4. HOW TO CUSTOMIZE YOUR NAVPILOT
4-6
Menu item Description
[Safe Helm Beep] Selects whether to sound a “beep” when OVRD mode is activated.
Select [OFF] for no “beep”, [ON] to sound a “beep”.
Note: This menu item appears under the following conditions:
• [Boat Type] is set to [EVCS-Pod Drive], [EVCS-Outboard],
[EVCS-Inboard] or [EVCS-In/Out] at installation.
• EVCS is SEASTAR SOLUTIONS OPTIMUS.
[Key Beep] When a key is pressed the system can release a beep sound.
[ON]: Key-press makes a beep sound;
[OFF]: No sound on key-press.
[Key Lock] Activates or deactivates the key lock for the control unit.
• [Lock]: Keys are locked. When any
key, other than , is pressed,
the message shown to the right ap-
pears. The lock icon (
) also ap-
pears.
To unlock the controls, press and hold , then press .
If the system is turned of with the key lock activated, when the
system is turned on next, the key lock will be active.
• [Unlock]: Keys are not locked.
[Sharing] The following installation settings can be shared and passed onto
the sub units on the same network: [Sensor in Use], [Units Setup],
[Heading Display], [Time Offset], [Mag. Var.], [STW Adjust].
The unit assign as [Master] shares its settings with units assigned
as [Sub].
Select the appropriate sharing level from the following options.
• [Stand Alone]: Disables sharing of settings.
• [Sub]: Assign the control unit as a sub unit.
• [Master]: This unit’s settings are passed to all sub units. Where
a FURUNO multi function display (MFD) is in the same network,
the MFD is automatically assigned as the [Master] and this op-
tion is not available.
[Group] The language and brilliance settings are shared within a group of
NAVpilot-300 control units and FI-70s. If the settings are adjusted
for one control unit or FI-70 in the group, all other units in the same
group are also adjusted, however MFD settings are not adjusted.
There are three groupings available: [A], [B] and [C]. Select an ap-
propriate group to assign a group to a control unit.
[Factory Default] Select [Yes] to restore factory default settings. The system is auto-
matically restarted after selecting [Yes].
[Save User
Settings]
Select [Yes] to save the current settings as user default settings to
the internal memory. The user default settings in the internal mem-
ory are overwritten with the current settings.
[Load User
Settings] Select [Yes] to load the setting data from the internal memory. The
current settings will be overwritten with the user default settings in
the internal memory.
[Alert Log] You can see which alert(s) has, or have been violated. A maximum
of 10 alerts are listed. When the capacity is exceeded, the oldest
alert is deleted to make a room for the latest.
[Sim/Slide] Activate or deactivate the demonstration mode. DO NOT select any
option other than [OFF] on board your boat. Options other than
[OFF] are intended for promotional use.
[Diagnostics] Perform various diagnostics on the NAVpilot system. Available in
the STBY mode only. For details, see section 6.4.
This controller is locked.
To unlock,
hold [menu] key down and
press [10>>] key.
10