Furuno NAVpilot-300, Руководство оператора

Страница: 54 / 101

4. HOW TO CUSTOMIZE YOUR NAVPILOT
4-4
10. Set the trim as required. The setting range is P5.0° to S5.0°, and the default set-
ting is 0.0°.
This setting compensates for yaw caused by rough seas or heavy loads. If the
boat has a port-side yaw, adjust the trim to starboard. Alternatively, if the boat has
a starboard-side yaw, adjust the trim to port.
Note: For boats with Fantum Feedback
™
, [Manual Trim] settings are not used.
The menu items is available, however any change in settings is ignored.
11. Close the menu.
4.1.3 Speed calculation
Speed is normally entered automatically, from your navigator. If the navigator fails,
manually enter the speed by following the procedure below.
1. Open the menu.
2. Select [Speed Calculation].
3. Select [AUTO] or [MANUAL], as appropriate. For [AUTO] go to step 4. For [MAN-
UAL], do as follows:
1) Select the current value.
2) Set a value. The setting range is 0.1 to 40.0 knots and the default setting is
30.0 knots.
4. Close the menu.
4.2 Rudder Drive Level (For Fantum Feedback
™
)
For Fantum Feedback
™
, the driving power of steering can be adjusted by the rudder
drive level. The higher the setting, the greater the rudder is turned.
1. Open the menu.
2. Select [Rudder Drive Level].
3. Set the required value. The setting range is 1 to 20. The default setting depends
on whether a rudder test is completed beforehand. Where the rudder test is com-
plete: the default is the test result; where the rudder test is not complete: the de-
fault setting is 6.
4. Close the menu.