Furuno NAVpilot-300, Руководство оператора, Страница: 94 / 101

APPENDIX 1 MENU TREE
AP-2
Safe Helm
Setup*
1 * 2
Safe Helm(OFF, ON )*
2
Return Delay (1sec to 20sec, 5sec )*
2
Safe Helm Response (1 to 10, 5 )* 2
Safe Helm Beep (OFF, ON )*
2
#5
#4
Power Assist
Setup*
1 * 2
Power Assist (OFF, ON )* 2
Power Assist STBY ( OFF , ON)*
2
Power Assist Rudder Speed (1 to 10; 10 )*
2
For Speeds Under (1.0 to 25.0 kn, 10.0 kn )* 2
#6 System Setup*
2
Key Beep (OFF, ON )*
2
Safe Helm Beep (OFF, ON )*
4
Key Lock ( Unlock , Lock)* 2
Sharing ( Stand Alone , Sub, Master)*
2
Group ( A , B, C)*
2
Factory Default ( No , Yes)* 2
Save User Settings ( No , Yes)*
2
Load User Settings ( No , Yes)*
2
Alert Log (Shows the Alert Log)* 2
Sim/Slide ( OFF , Slide Show, Simulator, Sim W/Drive)*
2
System Data (Shows the system data screen)* 2
Diagnostics*
2
( OFF , Processor Unit, Control Unit, Keyboard Test,
Screen Test, Rudder Test*
3
, Helm Sensor Test*
1
)
KEY LOCK ( UNLOCK , LOCK)
DIRECT ( OFF , ON)
BACKLIGHT (OFF, ON )
PAIRING ( NO , YES)
CALIBRATION ( NO , YES)
SLEEP MODE ( 30SEC , 1MIN, 3MIN)
AUTO OFF ( OFF , 1H, 3H, 6H)
ALARM
DIAGNOSTIC
BUZZER (OFF, ON )
VIBRATION ( OFF , ON)
BT TEST
SELF TEST
KEY TEST
GYRO TEST
SCREEN TEST
BUZZER TEST
VIBRATION TEST
RE MODE
SPURIOUS
ALL CLEAR (
NO , YES)
POWER CHANGE (1 TO 7; 7 )
BATTERY
GC-001 Menu Tree
then select
[System Menu]
Press
* 1 : Available only when the following settings and tests are completed at installation:
• [Drive Unit] is set to either [Safe Helm12V] or [Safe Helm24V].
• [Helm Sensor Test] is completed.
*
2
: Shown only when STBY or OVRD mode is active.
* 3 : Not shown when the installation setting for [Boat Type] is [EVCS-Pod Drive], [EVCS Inboard],
[EVCS- IN/OUT] or [EVCS-Outboard].
*
4
: Shown only when connected to SEASTAR SOLUTIONS OPTIMUS and [Boat Type] is [EVCS-Pod Drive],
[EVCS Inboard], [EVCS- IN/OUT], [EVCS Inboard] or [EVCS-Outboard].