Furuno NAVpilot-300, Руководство оператора, Страница: 55 / 101

4. HOW TO CUSTOMIZE YOUR NAVPILOT
4-5
4.3 Nav Data Source
This section covers how to select the source of nav data to use in the NAV mode.
1. Open the menu.
2.
If NAV mode is active , select [NAV Data Source].
If any mode other than NAV mode is active , select [Other Menu]
o
[Auto Pilot
Options]
o
[NAV Data Source].
A list of navigational devices connected to the same NMEA2000 network appears.
For the purpose of this example, the list shows a TZTL12F.
If your NMEA2000 network has more than one device capable of nav data output,
those devices are also listed. Each device is shown with its unique instance ID and
network ID. The instance ID is set when the device is first installed as part of the
NMEA2000 network. The network ID is unique to each device.
3. Select the appropriate device to use for nav data input to your NAVpilot-300.
4. Close the menu.
4.4 System Setup Menu
The [System Setup] menu provides various functions which once set do not require
frequent adjustment. Set the items in this menu according to operational needs, cur-
rent environment, etc. To open this menu, select [OTHER MENU] followed by [SYS-
TEM SETUP].
The following table lists the menu items in the [System Setup] menu, along with a brief
description for each item.
- - - - - - - - - - - - - - - - -
TZTL12F: 0: 000C2F
Device’s instance ID
(set at device installation)
Device’s unique
NMEA2000 network ID Source name
ON
Unlock
A
Manual Parameters Manual Parameters
Key Beep:
*: See following table.
ON
Safe Helm Beep:*
Group:
Key Lock:
Press
Press
Prev Ent Prev Ent
No
No
Factory Default:
Save User Settings:
No
Manual Parameters
Load User Settings:
Prev Ent
Alert Log:
1
1
Press
Press
1
Press
1
1
Press
1
Sharing:
Unlock
Manual Parameters
Prev Ent
System Data:
Sim/Slide:
Diagnostics:
OFF