Furuno FCV-1900/B/G, Руководство по установке

Страница: 27 / 52

3. INITIAL SETTINGS
20
3.3 Transducer Setting
The menu tabs names listed below are for setting up external transducers. This allows
you to adjust the transducer settings from the FCV-1900.
• DFF1/DFF3/BBDS1 transducer
• Telesounder (products sold only in Japan)
Select the transducer
1. Referring to section 3.2, open the [Service] menu.
2. After you have selected [Service], the following message appears.
3. Select [Yes] and push the ENTER knob to turn the power off.
4. Press the power key to turn the power on.
The [XDCR Setting] menu appears.
5. Select [XDCR type] at [HF XDCR select].
Confirm that the high freq. transducer is connected to the HF port.
CAUTION
Set the transducer data properly.
Wrong data setting may damage the
transducer and void the warranty.
Yes No
System will power down
automatically. Turn the
power on again, and
change the tarnsducer
setting.
Own XDCR Setting DFF1,DFF3,BBDS1 Transducer
HF XDCR Select
HF Connection
ޓ Freq
ޓ Transducer
Tx power
ޓ Voltage
ޓ Freq
ޓ Band width
ޓ TX mode
LF XDCR select
LF Connection
ޓ Freq
ޓ Transducer
ޓ Tx Power
ޓ Voltage
ޓ Freq
ޓ Band width
ޓ TX mode
Tankenmaru Connection
External Telesounder
Net Sonde
Save Setting
XDCR Type
Connected
200kHz
50/200-1T
1kW
120V
---kHz
---kHz
Std
XDCR Type
Connected
50kHz
50/200-1T
1kW
120V
---kHz
---kHz
Std
On
Off
Off