Fujitsu PRIMERGY TX120 S3, Руководство по модернизации и обслуживанию

Страница: 119 / 440

TX120 S3
Upgrade and Maintenance Manual 119
7 Hard disk drives / solid state
drives
This chapter provides information on how to install or remove HDD / SSD
modules and how to replace the SAS backplane. For information on SAS RAID
controllers, please refer to chapter
"Expansion cards and backup units" on
page 173 .
Safety notes
V
CAUTION!
●
The hard disk drive must not be removed from the installation frame
by anyone except a service technician.
●
The HDD / SSD modules (drives) must all be marked clearly so that
they can be put back in their original places after an upgrade. If this
is not done, existing data can be lost.
●
Do not touch the circuitry on boards or soldered parts. Hold the
metallic areas or the edges of the circuit boards.
●
Before removing a hard disk drive, wait for about 30 seconds until the
disk has stopped spinning completely.
●
When a hard disk drive is starting up, a resonant noise may be
audible for a short while. This does not indicate a failure.
●
Depending on the OS, you can configure the write cache settings for
the hard disk drives. If a power failure should occur while the write
cache is enabled, cached data may be lost.
●
When disposing of, transferring, or returning a hard disk or solid state
drive, wipe out the data on the drive for your own security.
●
Rough handling of hard disk drives may damage the stored data. To
cope with any unexpected problems, always back up important data.
When backing up data to another hard disk drive, you should make
backups on a file or partition basis.
●
Handle the device on a shock and vibration free surface.
●
Do not use the device in extremely hot or cold locations, or locations
with extreme temperature changes.
●
Never attempt to disassemble a hard disk or solid state drive.