Fujitsu Primergy RX600 S2, Руководство пользователя

Страница: 136 / 299

136
Chapter 5 Operations after OS Installation
5
Set as follows:
1. In the [Write debugging information] section, select the memory dump file type.
• Small memory dump (64KB)
Minimum information is recorded to the memory dump file.
Each time a fatal error occurs, a new file is created in the directory specified in [Small
dump directory].
• Kernel memory dump
Only kernel memory is recorded to the memory dump file.
• Complete memory dump (Recommended)
The whole system memory information is recorded to the memory dump file.
2. In [Dump file] or [Small dump directory], specify the directory to save the memory
dump file, with its full path.
In case of kernel memory dump or complete memory dump, if [Overwrite any existing file]
is checked, debugging information is overwritten to the specified file every time.
6
Click [OK] to close the [Startup and Recovery] window.
7
Click [OK] to close the [System Properties] window.
8
Restart the system.
The setting is enabled after the system is restarted.
■
Paging File Setting
Set up the paging file according to the following procedures:
1
Log on to the server with administrator privileges.
2
Check free space of the drive where the system is installed.
Check the required amount of free space according to "
■
Checking Hard Disk Free Space"
( pg.134).
If the drive has no free space, refer to "
■
Cannot Collect the Memory Dump" ( pg.268).
3
Click [Start]
→
[Control Panel]
→
[System].
The [System Properties] window appears.
4
Click the [Advanced] tab and click [Settings] in [Performance].
The [Performance Options] window appears.