Fujitsu PRIMERGY RX1330 M1, Руководство по модернизации и обслуживанию

Страница: 83 / 312

RX1330 M1
Upgrade and Maintenance Manual 83
Basic software procedures
5.2.12 Updating the NIC configuration file in a Linux
environment
In order to prevent errors caused by changing network device names ( eth<x> ),
it is recommended to store the MAC address (hardware address) of a network
interface card in the related NIC configuration file of the Linux OS.
When replacing a network controller or the system board with onboard LAN
controllers in a server running Linux OS, the MAC address will change but not
automatically be updated in the definition file.
In order to prevent communication problems, it is necessary to update the
changed MAC address stored in the related
ifcfg-eth<x> definition file.
To update the MAC address, proceed as follows:
I
Procedures may differ depending on your Linux OS or the definition file
on the client system. Use the following information as reference. Ask the
system administrator to change the definition file.
Ê
After replacing a network controller or the system board, switch on and boot
the server as described in section
"Switching on the server" on page 57 .
kudzu , the hardware configuration tool for Red Hat Linux, will launch at boot
and detect the new and / or changed hardware on your system.
I
kudzu may not launch at boot depending on the client’s environment.
Ê
Select Keep Configuration and Ignore to complete the boot process.
Ê
Use the vi text editor to specify the MAC address in the
HWADDR
section of
the ifcfg-eth<x> file:
I
The MAC address can be found on the type label attached to the
system board or network controller.
Example:
In order to modify the definition file for network controller 1, enter the
following command:
# vi /etc/sysconfig/network-scripts/ifcfg-eth1
In vi , specify the new MAC address as follows:
HWADDR=xx:xx:xx:xx:xx:xx
Ê
Save and close the definition file.