Fujitsu ETERNUS CS800 S5, Руководство пользователя

Страница: 342 / 634

Notifications Configuration
328
U41840-J-Z125-7-76
I
If you define a single community and set both the IP address and network mask
to 0.0.0.0 (or leave both blank), then IP address-based access control is
disabled. In this case, the SNMP agent is accessible from any IP address.
I
When entering IP addresses, never use an address that is in a reserved IP
address range. To see a list of reserved IP address ranges, click the quick tip
icon
[?] located near the IP address field.
4. In the Access Type drop-down box, select the access type for the community:
● Get - Allows SNMP get operations.
● Get/Set - Allows both SNMP get and put operations.
5. Select the Community status check box to enable the community.
Or clear the Community status check box to disable the community.
6. Click Apply .
Editing a Community
Edit an SNMP community to change the IP address or access type for the community. You
can also enable or disable the community.
To edit a community:
1. Click Edit .
The Edit SNMP Community page displays (see Figure 204 ).
IP Address / Network Mask Result
10.40.166.87
255.255.255.255
Allows access only from
10.40.166.87
10.40.166.87
10.40.166.87
Allows access only from
10.40.166.87
10.40.166.87
10.40.166.0
Invalid because the logical
bitwise operation (address
AND
mask) is not equal to the address
10.40.166.87
255.255.0.0
Invalid because the logical
bitwise operation (address
AND
mask) is not equal to the address
10.40.0.0
255.255.0.0
Allows access from any client
with address 10.40.xx.xx