Fujitsu ETERNUS CS800 S5, Руководство пользователя

Страница: 125 / 634

Initial Configuration, Connecting with the Network Running the Getting Started Wizard
U41840-J-Z125-7-76
111
Configuring the Network
Using the Network page, each physical Ethernet port in the ETERNUS CS800 can be
configured as a separate device. In addition, you can create bonded devices (logical ports)
consisting of two or more physical ports of the same link speed (1GbE or 10GbE). For each
port or device, you can specify the MTU (Maximum Transmission Unit) frame size, and you
can optionally assign the port or device to a VLAN (Virtual Local Area Network).
After you define devices (single port or bonded), you can create up to ten network interfaces
for each device. Each interface has its own IP address information, and you can specify the
types of traffic allowed on the interface (management, replication, or data). Finally, you can
add routing information for an interface to enable connectivity with devices on different
subnets.
I
You can choose to allow any traffic type (management, replication, or data) on an
interface. In this case, the routing of different traffic types, as well as firewall
capability, must be controlled using the network infrastructure (routers and
switches) that the ETERNUS CS800 is connected to.
Configuring the network includes the following major steps:
I
Before configuring the network, work with your network administrator to determine
the network settings that will be required to properly integrate the ETERNUS CS800
with your company’s network.
1. "Configuring General Network Settings" on page 111
2. "Configuring Bonding Details" on page 113
3. "Configuring Interface Details" on page 114
4. "Configuring Interface IP Addresses" on page 115
5. "Configuring Interface Routing" on page 117
6. "Applying Network Settings" on page 118
Configuring General Network Settings
Under General , enter the following network information as provided by your network admin-
istrator (see Figure 70 ):