Fujitsu ETERNUS CS800 S5, Руководство пользователя

Страница: 132 / 634

Running the Getting Started Wizard Initial Configuration, Connecting with the Network
118
U41840-J-Z125-7-76
Figure 74: Network Page: Routing Details
1. In the IP Address Table (above routing details), select an interface to add or modify
routing data. (To select an interface, click the radio button next to the interface index
name, for example,
bond0:2 .)
After selecting an interface in the IP Address Table , the Routing Details table below
expands to display available routes (if any).
I
A maximum of 8 routes per interface are allowed.
2. If necessary, click the Show link to show the routing details table.
3. Click Add Route to add a route to the selected interface.
Or select a route to edit its settings.
4. Enter the following network information as provided by your network administrator:
●
Destination - The destination network for the route.
●
Dest Netmask - The network mask for the route.
●
Dest Gateway - The gateway IP address used for
outgoing
traffic sent from the
interface to a host or client. (This is usually not the same as the default gateway.)
I
In the example shown in Figure 75 , to reach a host on the 10.50.50.x subnet,
you would enter 10.50.50.0 for destination network, 255.255.255.0 for the
destination netmask, and 10.20.20.1 as the destination gateway.
5. Click Update to save the changes you made to the Routing Details table. (Clicking
Update does not yet apply the new network settings to the ETERNUS CS800.)
Click Delete to remove IP routing information for the selected interface. Or click Undo
to revert all current Routing Details changes to the last update.
Applying Network Settings
For network changes to take effect, you must apply the changes, finalize the confirmation,
and reboot the system. To apply all changed settings on the
Network page to the
ETERNUS CS800, click Apply at the bottom of the page. Follow the prompts to confirm the
changes and reboot the system.