En-7
8.2. Front panel installation
(1) First, fit the lower part of the front panel, and insert top and bottom hooks. (3 top
sides, 5 middles)
Front panel
Top hooks
(3 position)
Top holes (3 position)
Indoor unit
Middle hooks
(5 position)
Middle hooks
(5 position)
(2) Attach the 10 screws.
(3) Attach the wire cover.
(4) Attach the 4 caps.
(5) Attach the intake grille.
CAUTION
Install the Front panel and Intake grille securely. If installation is imperfect, the Front
panel or Intake grille may fall off and cause injury.
9. REMOTE CONTROLLER INSTALLATION
• Check that the indoor unit correctly receives the signal from the remote controller, then
install the remote controller holder.
CAUTION
• Select the remote controller holder selection site by paying careful attention to the
following:
Avoid places in direct sunlight.
Select a place that will not be affected by the heat from a stove, etc.
9.1. Remote controller holder installation
•
Install the remote controller a maximum distance of 22 ft. (7 m) from the remote control
receiver. However, when installing the remote controller, check that it operates cor-
rectly.
•
Install the remote controller holder to a wall, pillar, etc. with the tapping screw.
remote controller
holder fixing
Remote
controller holder
Tapping screw
(small)
remote controller
mounting
Remote
controller
2
Push
1
Set
Overlap the insulation
Vinyl tape
Wrap with cloth tape
Cloth tape
Drain hose
Connection cable
Pipe
Drain hose
Drain hose
Connection pipe
Wall pipe
Connection cable
Left piping
For connection from the left rear
Pipe
Connection pipe
(heat insulation)
Indoor unit pipe
(heat insulation)
Bind the pipes together
so that there is no gap.
Seal A is used when the diam-
eter of gas pipe is Ø12.70 or
more.
Butt connection pipe (heat
insulation) against the indoor
unit pipe (heat insulation) and
wrap with Seal A so that there
is no gap.
Check the following:
GOOD
Drain hose
Saddle
Lifted up
Wave
End in water
PROHIBITED
8. FRONT PANEL REMOVAL AND INSTALLATION
Intake grill removal
Intake grill installation
b
a
Open the intake
grille. While gently
pressing the left
and right mounting
shafts of the intake
grille outward “a”,
remove the intake
grille in direction of
the arrow “b”.
c
While holding the
grille horizontal, set
the left and right
mounting shafts into
the pillow blocks at
the top of the panel
“c”.
To latch each shaft
properly, insert the
shaft until it snaps.
Press 4 places on
the intake grille to
close it completely.
8.1. Front panel removal
(1) Remove intake grille (Reference the intake grille removal.)
(2) Remove 4 caps.
(3) Remove wire cover.
(4) Remove 10 screws.
Screws (Wire cover)
Screws (10 position)
Caps (4 position)
Wire cover
NOTE:
When replacing the front panel, do not scratch or damage the louver.
(5) The front panel is pulled to the front, raising the upper surface, and a front panel is removed.
Front panel
9387082098-02_IM.indb 7
21/03/2016 10:12:57
