Fujitsu Siemens Computers PRIMERGY SX30, Руководство по эксплуатации

Страница: 88 / 101

88
U41169-J-Z156-4-74
Problem Solutions and Tips Fault Clearing
V
CAUTION!
It is imperative when replacing the fan module during operation that
you take no longer than 30 seconds, since otherwise the temperature
in the storage subsystem can exceed the permissible limit values.
After the fan module has been replaced successfully, both the status LED on the
fan module and the cooling status LED must be green again.
12.1.2.2 Cooling status LED is orange
In this case there is a cooling fault.
Ê Check whether or not all the fans have failed. In this case the status LED on
the fan module is orange (see
chapter “Fan Module” on page 39 ).
If the status LED on the fan module is green or yellow, the temperature in the
device is too high although the fans (or at least one of the fans) are working.
Check whether or not the ambient temperature is too high or the air outlet on
the rear panel of the device is obstructed.
All the fans have failed
Ê Immediately shut down the system to prevent overheating damage in the
device.
Ê
Replace the fan module (see section “Fitting/Removing the Fan Module” on
page 40 ).
V
CAUTION!
It is imperative when replacing the fan module during operation that
you take no longer than 30 seconds, since otherwise the temperature
in the storage subsystem exceeds the permissible limit values.
12.1.3 Server Management Status
This indication can be activated manually from the ServerView. Evaluation is
performed with a later version of the storage subsystem.