FujiFilm ALPHA 5 RYT-SX, Руководство пользователя

Страница: 287 / 547

CHAPTER 4 PARAMETER
Output Terminal Function Setting Parameters
4-91
4
4.7 Output Terminal Function Setting Parameters
Parameters marked " " in the "Power" field are enabled after the control power is turned
off then turned on again. (Check that the keypad (7-segment display) of the servo
amplifier is unlit when the control power is turned off.)
4.7.1 List (PA3_ )
Control mode
No.
PA3_
Name
Default
value
Power
Position Speed Torque
Record of
reference
value
51 OUT1 signal assignment
52 OUT2 signal assignment
53 OUT3 signal assignment *2)
54 OUT4 signal assignment *2)
55 OUT5 signal assignment *2)
56 OUT6 signal assignment *2)
57 OUT7 signal assignment *2)
58 OUT8 signal assignment *2)
59 OUT9 signal assignment *2)
60 OUT10 signal assignment *2)
61 OUT11 signal assignment *2)
62 OUT12 signal assignment *2)
63 OUT13 signal assignment *2)
64 OUT14 signal assignment *2)
65 OUT15 signal assignment *2)
66 OUT16 signal assignment *2)
Refer to
the table
below.
81 Monitor 1 signal assignment 2 -
82 Monitor 2 signal assignment 3 -
83 Monitor 1 scale 7.0 -
84 Monitor 1 offset 0 -
85 Monitor 2 scale 6.0 -
86 Monitor 2 offset 0 -
87 Monitor 1/2 output format 0 -
88
Command pulse frequency
sampling time for monitor
3 - - -
89
Feedback speed sampling time
for monitor
1 -
*2) The parameter applicable only for LS type
Paremeters marked "
○
" in the table are enabled in the corresponding control mode.