CONFIGURING USING THE BUBBLER’S FRONT PANEL
The Bubbler can be configured through its front panel using the
Set Stage
and
Setup
sub-menus or through a data logger. The Bubbler will retain the last input configuration
whether set through the Bubbler or the data logger. However, changes made using the
Bubbler’s interface will not be reflected in the data logger (unless it is an FTS Axiom
Datalogger).
SUB-MENUS
PRESSURE
PURGE
BLEED
STAGE
UNITS
4mA
20mA
Output mA
SLOPE
SITE/FAULT *
STAGE
OFFSET
TANK PSI
PURGE
SET STAGE
SETUP
DIAGNOSTICS
SITE
ADDRESS
RATE
TEMP F/C
AVG DUR
SDCARD
BATTERY
TEMP
VERSION
UPDATE
DATE
TIME
Only shows when
custom units (cu) are
indicated
Only shows if it is
a 4-20mA model
BUBBLER’S MENU TREE
* Normally the Status screen will
display the Site’s name. If a fault is
detected, the Site name will be
replaced with FAULT: followed by the
type of fault
STATUS SCREEN*
MAIN MENU
Select/
Accept
Navigate the bubbler’s
menus by using the arrows
and the Select/Accept
buttons on the front panel
7
