Frymaster FilterQuick FQG30-T, Инструкция по установке, эксплуатации и обслуживанию

Страница: 46 / 48

5-10
Code ERROR MESSAGE EXPLANATION
E65 CLEAN OIB SENSOR – XXX F OR XXX C - CALL
SERVICE Gas -The oil is back sensor does not detect
oil. Clean optional oil sensor.
E66 DRAIN VALVE OPEN – XXXF OR XXXC Drain valve is opened during cooking.
E67 SYSTEM INTERFACE BOARD NOT CONFIGURED
- CALL SERVICE Controller is turned on when the SIB board
is not configured. Call service.
E68 OIB FUSE TRIPPED – CALL SERVICE The VIB board OIB fuse has tripped and
didn’t reset. Call service.
E69 RECIPES NOT AVAILABLE – CALL SERVICE The controller has not been programmed
with product recipes. Replace controller
with factory programmed controller.
E70 OQS TEMP HIGH Oil temperature is too high for a valid OQS
reading. Filter at a temperature between
300ºF (149ºC) and 375ºF (191ºC).
E71 OQS TEMP LOW Oil temperature is too low for a valid OQS
reading. Filter at a temperature between
300ºF (149ºC) and 375ºF (191ºC).
E72 TPM RANGE LOW The TPM is too low for a valid OQS reading.
This may also be seen with fresh new oil.
The incorrect oil type may be selected in
the setup menu. The sensor may not be
calibrated for the oil type. See oil type chart
in instruction document 8197316. If issue
continues contact a FAS.
E73 TPM RANGE HIGH The TPM reading is too high for a valid OQS
reading. Dispose the oil.
E74 OQS ERROR The OQS has an internal error. If issue
continues contact a FAS.
E75 OQS AIR ERROR The OQS is detecting air in the oil. Check
the O-rings and check/tighten prescreen
filter to ensure no air is entering the OQS
sensor. If issue continues contact a FAS.
E76 OQS ERROR The OQS sensor has a communication
error. Check connections to the OQS
sensor. Power cycle the entire fryer battery.
If issue continues contact a FAS.