Frymaster FilterQuick FQG30-T, Инструкция по установке, эксплуатации и обслуживанию

Страница: 35 / 48

4-5
WARNING
Never leave the fryer unattended during this process. If the solution overflows, press
the ON/OFF switch to the OFF position immediately.
DANGER
Ensure that the frypot is completely free of water before filling with oil. When the oil is
heated to cooking temperature, water in the frypot will cause splattering.
4.5.4 Pre-filter Maintenance
The pre-filter requires regular maintenance. Every 90 days, or
more frequently if the flow of oil slows, remove the cap and clean
the attached screen.
1.
Wearing protective gloves use the supplied wrench to remove the cap from the pre-filter (Fig-
ure 7) .
2. Use a small brush to clear debris from the attached screen (Figure 8) .
3. Clean under a water tap and thoroughly dry.
4. Return the cap to the pre-filter housing and tighten with the attached wrench, ensuring the pre-
filter is tight. If the cap is not tight, air will leak around the pre-filter and slow the return of oil.
4.6 SEMI-ANNUAL CHECKS AND SERVICE
4.6.1 Clean Gas Valve Vent Tube
NOTE: This procedure is not required for fryers configured for export to CE countries .
1. Set the fryer power switch and the gas valve to the OFF position.
2. Carefully unscrew the vent tube from the gas valve. NOTE: The vent tube may be straightened
for ease in removal.
3. Pass a piece of ordinary binding wire through the tube to remove any obstruction.
4. Remove the wire and blow through the tube to ensure it is clear.
5. Reinstall the tube and bend it so that the opening is pointing downward
.
Figure 8
WARNING
DO NOT remove the pre-filter cap when a filter cycle is under way.
DO NOT operate the filter system with the cap removed. Wear protective gloves when han-
dling the cap. The metal and the exposed oil are hot.
Figure 7
DANGER
Wear protective gloves when removing the pre-filter. The filter
may be hot and cause severe burns.