Frymaster FilterQuick FQG30-T, Инструкция по установке, эксплуатации и обслуживанию

Страница: 32 / 48

4-2
There are no periodic preventive maintenance checks and services required for your filtration
system other than daily cleaning of the filter pan with a solution of hot water and a multi-purpose
detergent.
If you notice that the systems is pumping slowly or not at all, verify that the filter pan screen is on
the bottom of the filter pan, with the paper or pad on top of the screen. Verify that the two O-ring(s)
on the fitting at the right front of the filter pan are present and in good condition. Verify that the
pre-filter is clean.
4.2.4 Clean around AIF and ATO sensors – Daily
1. Clean the sediment from around the ATO sensors during clean and
filter when the oil is drained from the frypot.
2. Use a screwdriver or other similar object which allows access around
the probe (see Figure 1). Use caution to ensure that the probe is not
damaged.
3. Return the oil once the clean and filter is complete.
4.2.5 Clean Basket Lift Rods - Daily
On fryers equipped with basket lifts, wipe down the rods with dry, clean cloth to remove accumula-
tions of oil and dust.
4.3 WEEKLY CHECKS AND SERVICE
4.3.1 Clean Behind Fryers
Clean behind fryers. Shut off and disconnect the gas. Use the manual gas shut-off valve to shut off
the gas supply. The manual gas shut-off valve is located on the supply line before the quick discon-
nects. Then disconnect the gas line from the fryer via the quick disconnect.
4.3.2 Cleaning the Frypot - Quarterly
DANGER
Never operate the appliance with an empty frypot. The frypot must be filled with water
or oil before lighting the burners. Failure to do so will damage the frypot and may cause
a fire.
4.3.3 Clean Filter Pan, Detachable Parts and Accessories
As with the frypot, a deposit of carbonized oil will accumulate on the filter pan and detachable parts
and accessories such as baskets, sediment trays, or fishplates.
Wipe the filter pan and all detachable parts and accessories with a clean dry cloth. Use a cloth
dampened with a solution of a multi-purpose detergent. To remove accumulated carbonized oil.
Rinse and thoroughly dry each part. DO NOT use steel wool or abrasive pads to clean these parts.
The scratches that result from such scrubbing make subsequent cleanings more difficult.
Figure 1