Fronius TransSteel 3500 Syn, Руководство по эксплуатации

Страница: 96 / 144

Ito Ignition time-out function - length of wire that is fed before the safety
cut-out trips
Unit: mm (in.)
Setting range: OFF, 5 - 100 (OFF, 0.2 - 3.94)
Factory setting: OFF
NOTE!
The "Ignition time-out" function (ito) is a safety function.
The length of wire that is fed before the safety cut-out trips may differ from the
pre-set wire length, particularly when the wire is being fed at fast wire speeds.
SPt Spot time - spot / stitch welding time
Unit: s
Setting range: OFF, 0.1 - 5
Factory setting: OFF
SPb Spot break - stitch pause time
Unit: s
Setting range: OFF, 0.1 - 10 (in 0.1 s increments)
Factory setting: OFF
FAC Reset power source to factory setting
Press and hold down one of the "Parameter selection" buttons for 2 s to
restore the factory settings
- when "PrG" appears on the digital display, the power source has been re-
set.
IMPORTANT! When the power source is reset, all personal settings in the
Setup menu are lost.
When the power source is reset, operating points that were saved using
the "Save" buttons are not deleted, but are retained in the memory. The
functions in the second level of the Setup menu (2nd) are also not de-
leted. Exception: Ignition time-out function parameter (ito).
2nd Second level of the set-up menu (see "Set-up menu - Level 2")
Setup paramet-
ers for MMA
welding IMPORTANT! If you reset the power source using the FAC factory setup para-
meter, the hot-current time (Hti) and HotStart current (HCU) setup parameters
are also reset.
HCU HotStart current
Unit: %
Setting range: 100 - 200
Factory setting: 150
Hti Hot current time
Unit: s
Setting range: 0 - 2.0
Factory setting: 0.5
ASt Anti-stick
Unit: -
Setting range: On, OFF
96