Fronius TransSteel 3500 Syn, Руководство по эксплуатации

Страница: 82 / 144

Arc air gouging
CAUTION!
Risk of injury and damage from electric shock.
As soon as the mains switch is in the "I" position, the electrode in the arc air gou-
ging torch is live.
▶
Make sure the electrode does not touch any persons or electrically conduct-
ing or earthed parts (e.g. the housing, etc.).
CAUTION!
Risk of personal injury due to loud operating noise.
▶
Use suitable ear protection during arc air gouging!
1
Move the mains switch to the "I" position: all the indicators on the control
panel will briefly light up
2
Press the "Process" button to select the MMA welding process:
The welding voltage is applied to the welding socket with a three second time
lag.
If the MMA welding process is selected, any cooling unit present is automat-
ically deactivated. It is not possible to switch it on.
IMPORTANT! Under certain circumstances, it may not be possible to change
welding parameters that have been set on a control panel of a system component
(such as remote control or wirefeeder) from the control panel of the power
source.
3
In the setup menu for MMA welding, set the AAG parameter to "on";
To enter the setup menu, see page
93 .
NOTE!
Settings for the break voltage and the starting current time are ignored.
4
Exit the setup menu for MMA welding
5
Press the "Parameter selection" button to select the amperage parameter.
6
Using the adjusting dial, adjust the main current according to the electrode
diameter as indicated on the electrode packaging
The amperage value is displayed in the left-hand digital display.
NOTE!
At higher amperages, guide the arc air gouging torch with both hands!
▶
Use a suitable welding helmet.
7
Open the compressed air valve on the handle of the arc air gouging torch
8
Initiate processing
The tilt angle of the carbon electrode and the gouging speed determine the
depth of an air gap.
82