Fronius TransSteel 3500 Syn, Руководство по эксплуатации

Страница: 71 / 144

MIG/MAG standard manual welding
General The MIG/MAG standard manual welding process is a MIG/MAG welding process
with no synergic function.
Changing one parameter does not result in any automatic adjustments to the
other parameters. All of the variable parameters must therefore be adjusted indi-
vidually, as dictated by the welding process in question.
Available para-
meters The following parameters are available in MIG/MAG manual welding:
Wire feed speed
1 m/min (39.37 ipm) - maximum wire feed speed, e.g. 25 m/min (984.25
ipm)
Welding voltage
TSt 3500: 15.5 - 31.5 V
TSt 5000: 14.5 - 39 V
Dynamic
for influencing the short-circuiting dynamic at the moment of particle
transfer
Welding current
only for displaying the actual value
MIG/MAG
standard manual
welding
1
Press the "Process" button to select the desired welding process:
- MIG/MAG standard manual welding
2
Press the "Mode" button to select the desired MIG/MAG mode:
- 2-step mode
- 4-step mode
- In MIG/MAG standard manual welding, special 4-step mode corres-
ponds to conventional 4-step mode.
IMPORTANT! Under certain circumstances, it may not be possible to
change welding parameters that have been set on the control panel of a
system component (TR 2000 or TR 3000 remote control) on the control
panel of the wirefeeder.
3
Press the "Parameter selection" button to select the wire speed parameter
4
Use the adjusting dial to set the desired value for the wire speed
5
Press the "Parameter selection" button to select the welding voltage para-
meter
6
Use the adjusting dial to set the desired value for the welding voltage
The welding parameter values are shown in the digital display located
above them.
71
EN